I've been loving all of these spiked hair accessories that I've been seeing around lately (this
Solene Lord of War comb by
Maison Michel is particularly transcendent) and really wanted to make a few variations of my own.
The spiked hair combs and barrettes are pretty simple to make and just take some super glue and a little patience. The headband project requires a little more elbow grease but I think the result is well worth the trouble.
For the comb/barrette:
plastic or metal comb/barrette
liquid super glue
ruler (optional)
For the headband:
flexible rubber or plastic headband
awl
drafting pencil (optional)
ruler (optional)
Spiked Comb/Barrette
Line up your spikes next to the comb or barrette to figure out how you want them spaced and how many spikes you will need. You can use a ruler to evenly space them if you like. Make sure the area you are gluing the spikes to on your comb/barrette is as large as or larger than the base of your spikes. If the spike isn't completely anchored to the surface, it could pop off after the glue dries.
Apply glue to the base of the spike. Be sure to use a glue that says it is compatible with both metal and plastic. I like the brush-on Krazy Glue because its brush applicator is really easy to use and cuts down a lot on mess. Place the spike unto the comb/barrette. Start at one end. You'll have a few seconds to scoot it around if it isn't in the perfect place at first. Hold it in place for at least 30 seconds for the glue to set up. You may have to hold onto it for longer depending on the glue you are using. Apply your next spike to the opposite end and then start working out from the middle, this will help you judge exactly where to put the remaining spikes.
After your spikes are firmly in place, you can go back and add a little extra glue in any gaps between the spikes and the comb/barrette. Be sure to let your piece dry for a few hours before you start to play with it in you hair. Once it's completely dried, you can scratch off any glue mess that may be left behind on the surface.
Spiked Headband
Set out your spikes next to your headband in a pattern you like. For this project, you'll need spikes that are made to be attached with screws.
A screw-back spike
I chose to only put spikes on the side half of my headband but you could also have spikes all the way around or just in the middle. I just eyeballed where to put my spikes but if you prefer, use a ruler to space the spikes evenly and mark where you want to place them with a contrasting drafting pencil or with a small indentation from the awl.
Use the awl to poke holes where you've marked the headband. If you don't have an awl, you can use a sharp screw and a screw driver to drill the holes. I ended up having to use a screw to enlarge my holes because my awl wasn't big enough. Be sure to work on a surface you won't damage.
Once all of your holes are poked, push the screws that came with your spikes through them.
Attach your spikes! You can use all matching ones or a mix of different types. You can also swap out the spikes whenever you're in the mood for something new!
Posts
